Rovan Baja 2nd Gen Reverse Gear Kit

Rovan Baja 2nd Gen Reverse Gear Kit

Have your buggy do the most bizzare thing you could imagine and have it reverse, thats right that power beast that always manages to go over the start line or get knocked into the bush (because we never drive in there ourselves) and you have to take the walk or drive the circle to reset well no more, just pop it in reverse and back you go. Yes its now not only the battery boys that have the adavantage we do to.

NOTE *

Trimming of the body will be required for fitment also the servo does need the endpoint setting to get the sweet spot for switching over and if not set it will damage the servo! ( if you disconnect the servo arm rod from the arm while you feel the setting then adjust the servo arm to match before conneting the two it will be easier to set. Due to this setting up thats required there is no warranty on the servo as its added at no additional charge).

Fitting Help

When setting up the endpoints on the servo, you need to remove the connecting arm from the servo arm and unscrew the servo arm from the servo. Once done dial down the endpoints on the chosen channel (instore I had it at 16 out and 26 in) this was done by eye, seeing where the servo arm positioned itself in the most near and far positions and ensuring these lined up with the lock positions of the forward and reverse gear, when checking the gear shift you will have to turn the clutch bell to ensure the gear shift is fully in position.

Once you have fully setup the throw of the arm you can screw the arm in place and connect the connecting arm and test the shift if done correctly the clutch bell will turn the diff smooth in forward and in reverse.

Colour: Black

Position: Rear

Compatible with:

KM Buggy
KM T1000
HPI Baja 5B
HPI Baja 5SC
HPI Baja 5SC
Rovan Buggy
Rovan 5T
Rovan BLT